To effectively insulate your basement for energy efficiency and to create a comfortable space, you need to properly control moisture in the space.

Most basement water leakage results from either bulk moisture leaks or capillary action. Bulk moisture is the flow of water through holes, cracks, and other discontinuities into the home’s basement walls. Capillary action occurs when water wicks into the cracks and pores of porous building materials, such as masonry blocks, concrete, and wood. These tiny cracks and pores can absorb water in any and every direction—even upward.

The best approaches for preventing these problems will depend on your local climate, and your house’s type of insulation and style of construction. However, the following general rules apply to most basement designs for creating a water-managed foundation system (see the illustration below):

1. Keep all untreated wood materials away from contact with the earth.

2. Provide drainage, such as gutters, to conduct rainwater away from the house.

3. Slope the earth away from all sides of the house for at least 5 feet at a minimum 5% grade (3 inches in 5 feet). Establish drainage swales to direct rainwater to a desired location.

4. Add a sill gasket to provide air sealing.

5. Install a protective membrane, such as caulked metal flashing or an EPDM-type membrane, to serve as a capillary break that reduces wicking of water up from the masonry foundation wall. This membrane can also serve as a termite shield on top of foam board insulation.

6. Damp-proof all below-grade portions of the foundation wall and footing to prevent the wall from absorbing ground moisture by capillary action.

7. Place a continuous drainage plane over the damp-proofing or exterior insulation to channel water to the foundation drain and relieve hydrostatic pressure.

Drainage plane materials include special drainage mats, high-density fiberglass insulation products, and washed gravel. All drainage planes should be protected with a filter fabric to prevent dirt from clogging the intentional gaps in the drainage material.

8. Install a foundation drain directly below the drainage plane and beside the footing, not on top of it. This will prevent water from flowing against the seam between the footing and the foundation wall. Surround a perforated 4-inch plastic drainpipe with gravel and wrap both with filter fabric.

9. Underneath the basement’s slab floor, install a capillary break and vapor diffusion retarder, consisting of a layer of 6- to 10-mil polyethylene over at least 4 inches of gravel.

Consult a qualified builder, basement designer, and/or insulation contractor in your area for more specific basement moisture control measures relative to your climate and your house’s insulation type and construction style.

Information courtesy of EERE