To effectively insulate your crawlspace for energy efficiency and to create a comfortable home, you need to properly control moisture in it. A crawlspace is susceptible to moisture and deterioration problems because of contact with the earth.
The best approaches for preventing these problems will depend on your local climate and the style of your home’s construction. However, the following general guidelines for creating a water- managed foundation system apply to most crawlspace designs: 1. Keep all untreated wood materials from direct contact with the earth.
2. Provide rain drainage, such as gutters, to conduct rainwater away from the house.
3. Slope the earth away from the house for at least 5 feet at a minimum 5% grade (3 inches in 5 feet). Establish drainage swales to direct rainwater to desired locations around the house.
4. Add a sill gasket to provide air sealing.
5. Install a protective membrane, such as an EPDM-type membrane, to serve as a capillary break that reduces wicking of water from the masonry wall. This membrane, in addition to metal flashing, can also serve as a termite shield.
6. Damp-proof the below-grade portion of the foundation wall to prevent it from absorbing ground moisture by capillary action.
7. Install drainage plane material or gravel against the foundation wall to relieve hydrostatic pressure and channel water to the foundation drain. 8. Provide a foundation drainage system at the bottom of the footing, not on top, when the foundation floor (interior grade) is below the exterior grade. Surround a perforated 4-inch drain pipe with gravel, and cover with filter fabric.
9. Install a 6-mil polethylene vapor diffusion barrier across the crawlspace floor to prevent soil moisture from migrating into the crawlspace. Overlap and tape all seams by 12 inches. Seal the polyethylene 6 inches up the crawlspace walls. As an option, pour 2 inches (51mm) of concrete over this to protect the polyethylene from damage.
Get Pre-Screened Basement Drainage Help in Your Area
Information courtesy of EERE
