Expert Advice for Home Improvement & DIY Repair
Home Buying Guides How It Works Repair & Care DIY & Install Search Forums
November 8, 2009
Trying to save on your heating bill? Check out How to Save Money On Your Heating Bill.

--Don
Home Improvement
Articles & Advice
Interior
Improvements
Exterior
Improvements
Construction
& Real Estate

Don Vandervort, Head Homeboy, has written more than 30 DIY home improvement books, been a segment host on HGTV, served as MSN.com's home improvement expert and written countless magazine articles.
  Email  Print  Link
How to Replace a Fluorescent Tube Holder or Ballast
You can replace a ballast or tube holder if you're fairly familiar with wiring.

1) Turn off the power to the circuit.

2) Remove the tube and the cover plate that conceals the workings.

3) Disconnect or cut the wires to the tube holder or ballast and remove.

4) Strip 1/2 inch of insulation from the ends of the wires.

5) Mount the component and connect the wires with wire nuts.

6) Re-place the cover and tube.

7) Turn the circuit back on.

8) Turn the switch on.
Related Articles on HomeTips

DIY & Installation Projects (11)
How It Works (2)
Buying Guides & Reports (8)
Repair & Care (9)

 
Have a Question About This?
Search the HomeTips Forums   Search

Related Search Terms:  replace fluorescent light holder, how to replace fluorescent light ballast, replace fluorescent light tube holder, replace fluorescent light bulb holder, how to replace fluorescent light bulb ballast, how to fix fluorescent light ballast
  Home   Buying Guides   How It Works   Repair & Care   DIY & Install   Search   Forums    
Site Map | Copyright | Terms of Use | Privacy Policy | About HomeTips | Advertise | Contact | Tell a Friend