 |
 |
 |
A/C & Cooling |
|
|
Air & Water Quality |
|
|
Appliances |
|
|
Basement, Attic & Loft |
|
|
Bathrooms |
|
|
Cabinets & Countertops |
|
|
Car, Garage & Shop |
|
|
Childproofing |
|
|
Closets & Storage |
|
|
Decorating & Furnishing |
|
|
Design, Plan, Build |
|
|
Doors |
|
|
Electrical & Lighting |
|
|
Floors & Stairs |
|
|
Green Home, Save Energy |
|
|
Heating & Fireplaces |
|
|
Home Tech |
|
|
Kitchens |
|
|
Landscape & Structures |
|
|
Lawn & Garden |
|
|
Paint & Painting |
|
|
Plumbing & Fixtures |
|
|
Pools, Spas & Saunas |
|
|
Real Estate & Finance |
|
|
Roof, Chimney & Gutters |
|
|
Safe & Secure Home |
|
|
Seasonal, Family & Fun |
|
|
Siding, Columns & Detail |
|
|
Walls & Ceilings |
|
|
Windows & Skylights |
|
|
|
|
|
|
How to Install a Washing Machine |
When you buy a new washer, you can usually pay a small fee to have the appliance delivered and hooked up. But you can also undertake installation yourself. The job is quite simple if the laundry area is set up for the machine.
If you're installing a washing machine in a new location, you will need to run hot and cold water supply pipes to the connection point and terminate each with a shutoff valve and, if necessary, a water-hammer arrester.
If there is an existing laundry sink, you can hook the washer's drain hose over the sink's edge. If there is no sink or laundry tub nearby, the washer will need to drain into a standpipe, which is a 2-inch-diameter pipe with a built-in trap that taps into the nearest drainpipe. The top of the standpipe should be between 18 and 30 inches above the trap (some codes allow a range up to 42 inches). The trap should be 6 to 18 inches above the floor. Standpipes are available with built-in traps or can be assembled from scratch using standard drainpipe and elbow fittings.
A single-lever valve is an alternative to conventional washing machine shutoff valves. With this type, you just flip the lever to shut off the water supply when the machine is not in use. Because the hoses that connect a washing machine can leak or burst, this is a good way to prevent an unexpected flood.
Washing machines are designed to operate on flat, level floors. After positioning the appliance, check the top for level. If necessary, adjust the feet at the front to properly level the machine.
| 1) Screw the washing machine's water supply hoses onto the connections at the back of the washing machine. If the hoses are marked, be sure to orient them to hot and cold accordingly. | 
| | 2) Connect the washing machine supply hoses to the proper valves. Scoot the appliance into place. Level the top of the machine, adjusting its front feet as needed. |  |
3) Put the drain hose into the standpipe (or laundry sink). Turn on the water supply valves, and check for leaks.
| 
|
Copyright Sunset Publishing Corporation
|
|
|
Got a question about How to Install a Washing Machine? Ask or search the HomeTips Forums
|
|
|
|
|
|
|
|
|
|
|